Servopumpe
Cardone : 20130
Varenummer: CDO20130
Remanufactured Power Steering Pump
CARDONE Remanufactured Power Steering Pumps are engineered to meet or exceed O.E. performance. Original designs are scrutinized for potential improvement, and where applicable, design upgrades are implemented to produce a more durable part than the origin
- Contains Electronic Components: No
- Does it require SDS: No
- E-Waste: No
- FAA_A1: A whining pump is usually caused by air in the power steering system. Inspect the reservoir for proper fluid level. If fluid has foam or air bubbles present, air has entered the system or has not been properly bled (ensure all hoses/clamps are tight). Some systems require special vacuum bleeding procedures.
- FAA_A2: The problem is most likely in the steering unit
- FAA_A3: The pulley may have cracked upon removal. If the shaft was mushroomed before removing the pulley, it has now enlarged the bore in the pulley. The pulley must be replaced.
- FAA_A4: There may be debris in the flow control valve bore not allowing the flow control valve to move as it should. (Valve and bore are located behind the high pressure fitting on the pump). The system must be checked for contamination and flushed.
- FAA_A5: Yes. Some O.E. manufacturers recommend that power steering fluid be changed at 50,000 miles and continue at that interval. Just like engine oil, power steering fluid will eventually break down and carry suspended contaminants from component wear and breakdown. Follow your vehicle's O.E. manufacturer's recommendations on fluid change intervals.
- FAQ_Q1: Why is the pump making a whining noise all of the time?
- FAQ_Q2: Why do I still have hard steering in one direction after I replaced the pump?
- FAQ_Q3: I bought a replacement power steering pump and my original pulley has a loose fit on the replacement pump shaft. What should I do?
- FAQ_Q4: I only have assist when increasing engine rpm after installing the replacement pump. What's causing this?
- FAQ_Q5: Should I ever change my fluid, even though nothing is wrong?
- Filter Included: No
- Hose Port Type: Seat
- Housing Material: Cast Iron
- Inlet Attachment Type: Barb
- Inlet Quantity: 1
- Is Item A Chemical: No
- Is Or Contains A Battery: No
- Is Or Contains A Bulb: No
- Is Prop Sixty Five Affected: No
- Is the item CARB affected: No
- Mounting Hardware Included: No
- Outlet Attachment Type: Threaded
- Outlet Quantity: 1
- Outlet Thread Size: 5/8-18
- Package Contents: Hydraulic Pump; Instruction Sheet; Sealing Kit
- Product Condition: Remanufactured
- Pulley Attachment Type: Press-On
- Pulley Belt Type: V-Belt
- Pulley Included: No
- Remote Reservoir: No
- Remote Reservoir Included: No
- Reservoir Cap Included: No
- Reservoir Included: No
- Shaft Type: Press-On
- Type: Hydraulic
- CDO20132: Replaced
- EDL16018: Replaced
- EVE60353: Replaced
